Chauvet MINWASH DMX-512 Uživatelský manuál

Snapshot OK on Dimmer Outdoor OK Sound Activated DMX512 Master/Slave 115V/230V Switch Replaceable Fuse User Serviceable Duty Cycle MiN Wash™

4. OPERATING INSTRUCTIONS Navigating the Control Panel Access control panel functions using the four panel buttons located directly underneath the LCD

Menu Map MiN™ Wash User Manual 11 2008-07-15/12:47

User Configurations TO SET THE PAN TO INVERTING OR NON-INVERTING: 1) Press the Mode button until it shows or

Operation Stand-Alone Mode (Auto Mode): This mode allows a single unit to run to a factory installed program in one of two speeds. 1) To set the fix

DMX Channel Values (13 Channel) CHANNEL VALUE FUNCTION1 000 Ù 255 Pan 2 000 Ù 255 Pan Fine 3 000 Ù 255 Tilt 4 000 Ù 255 Tilt Fine 5 000 Ù 255

DMX Channel Values (5 Channel) CHANNEL VALUE FUNCTION 1 000 Ù 255 Pan 2 000 Ù 255 Tilt 3 000 Ù 007 008 Ù 134 135 Ù 239 240 Ù 255 Dimmer/Strobe

Troubleshooting Symptom Solution(s) Applies to Lights Foggers & Snow Controllers Dimmers& Chaser Auto shut off Check fan thermal switch rese

Technical Support Address: Service Dept. 3000 N 29th Ct, Hollywood, FL 33020 (U.S.A.) Support (Email): [email protected] Telephone: (954) 929-

General Maintenance To maintain optimum performance and minimize wear fixtures should be cleaned frequently. Usage and environment are contributing f

MiN™ Wash User Manual 19 2008-07-15/12:47 Technical Specifications WEIGHT & DIMENSIONS Length...

TABLE OF CONTENTS 1. Before You Begin ...

1. BEFORE YOU BEGIN What is included ¾ 1 x MiN™ Wash ¾ Power Cord ¾ Warranty Card ¾ User Manual Unpacking Instructions Immediately upon receiving a

Safety Instructions Please read these instructions carefully, it includes important information about the installation, usage and maintenance of thi

2. INTRODUCTION Features CONTROL FEATURES • 5 or 13-channel DMX-512 LED moving yoke color wash • Pan: 540o / tilt: 270o • RGB color mixing • Vari

DMX Channel Summary 5 Channel Mode CHANNEL FUNCTION 1 Pan 2 Tilt 3 Shutter 4 Color Macro 5 Reserved Product Overview Lens Projector Head

3. SETUP Disconnect the power cord before replacing a fuse and always replace with the same type fuse. Fuse Replacement The fuse is located inside

CABLE CONNECTORS CABLE CONNECTORS Cabling must have a male XLR connector on one end and a female XLR connector on the other end. Cabling must have a m

Master/Slave Fixture Linking 1. Connect the (male) 3 pin connector side of the DMX cable to the output (female) 3 pin connector of the first fixture.