Chauvet DL-LEDW Uživatelský manuál stáhnout pdf (Strana 15)

WELL™ 2.0 User Manual Rev. 01 Page 11 of 28

Wireless

Operation

The WELL™ 2.0 can operate in W-DMX mode up to 300 m (900 feet) from the W-DMX

transmitter. The W-DMX receiver in the WELL unit must be paired with the W-DMX

transmitter for wireless operation.

Initial Setup

1) Turn the W-DMX transmitter on.

2) Connect the W-DMX transmitter to a DMX controller.

3) Place the WELL™ 2.0 unit within 300 m from the W-DMX transmitter.

4) Disconnect any DMX cable from the WELL™ 2.0 unit.

5) Push the antenna release to allow the W-DMX antenna to extend outside the metal

housing.

6) Set the antenna in the upright position.

7) Turn the WELL™ 2.0 unit on.

Configuration

1) From the WELL’s control panel, go to RUN > DMX.

2) Select the start address, as with any other DMX compatible product.

3) Go to WDMX > ACTI.

4) Select ON.

Fixture Pairing

Fixture Already Paired

1) If the WELL™ 2.0 unit has already been paired with the WDMX transmitter, the red

LED on the On/Off switch will flash slowly.

2) In this case, the WELL™ 2.0 unit is ready to work in wireless mode.

Pairing the WELL™ 2.0 Unit and a new W-DMX Transmitter

1) From the WELL’s control panel, go to WDMX > REST.

2) Select YES (the red LED on the On/Off switch will illuminate solid).

3) From the W-DMX transmitter, press <RESET> (the SIGNAL indicator will flash).

4) Once the transmitter has found the WELL fixture, the SIGNAL indicator on the W-

DMX transmitter will illuminate solid.

5) The red LED on the On/Off switch will flash slowly indicating the presence of DMX

signal.

WDMX Setup

Control Panel

WDMX Transmitter

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 27 28

Žádné komentáře

Chauvet DL-LEDW Uživatelský manuál Strana 15