Chauvet Legend 6000X Uživatelský manuál

LEG-6000Legend™ 6000X (575W) USER MANUAL CHAUVET, 3000 N 29th Ct, Hollywood, FL 33020 U.S.A (800) 762-1084 – (954) 929-1115 FAX (954) 929-5560 www

Operating Instructions Applying changes to Functions (Quick Instructions) Unless otherwise stated changes in the control board can be applied in the

Operating Instructions If this is your first time addressing a fixture using the DMX-512 control protocol than I suggest jumping to the Appendix Secti

Operating Instructions {Shut} - Shutter auto-close The shutter will close momentarily during color changes. The shutter will re-open once the desired

Operating Instructions {dF.SE} - Fixture Reset (excludes Pan & Tilt) This function will re-initialize the fixture with exception of the Pan and Ti

APPENDIX DMX Primer There are 512 channels in a DMX-512 connection. Channels may be assigned in any manner. A fixture capable of receiving DMX-512 wi

Appendix DMX Channel Values 16 Bit Movement CHANNEL VALUE FUNCTION 1 000 Ù 255 Dimmer Closed > Open (0-100%) 2 000 Ù 001 002 Ù 007 008 Ù 0

Appendix CHANNEL VALUE FUNCTION 8 000 Ù 063 064 Ù 127 128 Ù 143 144 Ù 255 Beam Effect Full Beam Frost Filter Flat and wide beam effect at 0° Fl

Color Calibration This function is used to match a specific color across multiple fixtures. It provides the means to offset a given color wheel posi

Appendix General Troubleshooting Applies to Symptom Solution(s) Lights Foggers & Snow Controllers Dimmers& Chaser Auto shut off Check f

Appendix Technical Specifications WEIGHT & DIMENSIONS Length...

TABLE OF CONTENT TABLE OF CONTENT...

Before You Begin What is included ¾ DMX-DMW6000X Legend™ 6000X ¾ Power cord with plug ¾ HMI575 Discharge lamp ¾ 2 Clamp mounting brackets ¾ Manual ¾

INTRODUCTION Control Features Legend™ 6000X • Mechanical dimmer • Variable shutter/strobe (7fps) • Color wheel - 6 colors plus open - Red, Bl

LEG-6000 User Manual 5 Revision: 2007-03-06/09:06 Product Overview SEGMENT BUTTONS I/O PANEL OVERVIEW BUTTONS I/O PANEL MENU◄ Toggles

SETUP Lamp You will need to install a lamp prior to the initial operation of the fixture. A HMI575 high intensity discharge lamp is included.

Power Your product is equipped with an internal input-voltage select switch. Warning! Verify that the power select switch on your unit match

Mounting Orientation All models described in this manual can sit on stage or be mounted on a truss using a clamp in any position, provided, the

OPERATING INSTRUCTIONS Control Board On the control panel you can set the DMX address, reset the fixture and change fixture personality trait.