Chauvet Tiger DMX 60 Návod k obsluze stáhnout pdf (Strana 105)

4. Palettes - Page 137

Pearl 2008 Manual - 16th July 2007

any fixture of the same type. Individual palettes will set individual

values to each fixture.

2> Select the attributes you want to recall from the palette. The

Dimmer attribute button will recall everything stored in the palette

(the LEDs on the buttons show you which attributes are active)

3> Press the Focus button, then the

palette page you want if the

pages are displayed, then press

the softkey for the palette entry

you want (or Softkeys F and G go

up and down the list). The

selected attributes of the fixtures

will be set to the palette values.

The console will stay in “Apply

palette” mode until you press

Exit.

• It’s easiest if you only save one

type of attribute (such as pan/tilt)

into each palette, then you can

just leave the Dimmer attribute

button selected when recalling

the palette. If you store a mixture

of attributes, you always have to

make sure that the correct

attributes are selected when

recalling a palette, and this is an extra step which you could do

without.

• You can also use the grey Palette/Flash buttons below the preset

faders to apply palettes 1-30. While you hold the button, the top

line of the display shows the legend for the attribute (White,

Green etc). When you release the button, the palette is applied. If

you decide you don’t want to apply the palette, press the Focus

button before you release the grey Flash button.

• You can recall a palette by number, type the palette number on

the keypad and press B [Recall palette].

4.2.2 Palette pages

If Palette Pages are turned Off (User Settings 5), palettes 1-30 are

available from the Palette/Flash buttons on every Fixture page. If the

option is On, then Fixture Page 0-- has palettes 1-30, Page 1-- has 31-

60, Page 2-- has 61-90 and Page 3-- has 91-120.

4.2.3 Setting a palette to all fixtures (Quick palette)

You can apply a palette to all patched fixtures. Ensure no fixtures are

selected, press Focus, then the palette page you want. Press the

softkey for the palette you want to apply. The palette will be applied to

all fixtures.

Alternatively, hold down one of the grey Palette/Flash buttons. The

palette legend will be displayed in the top line of the screen. When you

release the button, the palette will be applied to all fixtures. If you

decide you don’t want to apply the palette, press Focus before you

release the palette button.

User Setting 6 (Hold AVO and press softkey C) must be enabled for

1 2 ... 100 101 102 103 104 105 106 107 108 109 110 ... 205 206

Komentáře k této Příručce

Žádné komentáře

Chauvet Tiger DMX 60 Návod k obsluze Strana 105

Komentáře k této Příručce