Chauvet Tiger DMX 60 Návod k obsluze stáhnout pdf (Strana 96)

Page 128 - 3. Controlling dimmers and fixtures

Pearl 2008 Manual - 16th July 2007

If you have selected a range of fixtures, or a group, the Pearl has

functions to step through the selected fixtures one at a time. This can

make it easier to program a range of fixtures because you don’t have to

select each one manually.

This mode uses the “Sequence Control” buttons which are normally

used for controlling chases.

1> Put the Pearl into Fixture Select mode by holding down the AVO

button and pressing Softkey B until

the option shows [Fixture Control

Enabled]

2> Select a range of fixtures or a

group

3> The



(Reverse) and



(Forward)

buttons will select the fixtures in

the range one at a time

4> The



(Bounce) button will

highlight the output of the selected

fixture so you can see it on stage

(the button LED is lit when in

Highlight mode)

5> The Review button reselects the whole range of fixtures.

• The Sequence Control buttons stay in this mode until you change

them back by holding AVO and pressing Softkey B again. This

means you cannot use them for controlling chase direction.

• You can also use the left and right arrow keys to step through

selected fixtures.

• The selected fixture from the range will light up, and the other

fixtures will go out (if the “Highlight Enabled” option in the ML

menu is turned on).

3.1.6 The Align and Flip functions

The Align function allows you to copy an attribute from one fixture to

others. This can be useful if you want to set a row of moving lights to

have the same tilt position, or if you want to copy a colour from one

fixture onto other fixtures.

1> Press an attribute button to select the attribute you want to align.

2> Select the fixture to use as the reference

3> Select the other fixtures you want to align to the first one

4> Press ML Menu, then D [Align <attribute name>].

5> The attributes will be copied to all the selected fixtures.

• You can align all attributes of the fixtures using Softkey C [Align

Fixtures] (it doesn’t matter which attribute is selected).

• If you use a group to select the fixtures, the one you selected first

when you recorded the group will be the reference fixture.

• If Tracking mode is on (see page

131), aligning the Pan/Tilt

attribute will cause all the fixtures to point at the same place on

the stage rather than copying the actual Pan/Tilt values.

The Flip function is used with moving head fixtures. This type of fixture

has two possible pan and tilt positions for each point on stage, and the

Sequence control buttons

1 2 ... 91 92 93 94 95 96 97 98 99 100 101 ... 205 206

Komentáře k této Příručce

Žádné komentáře

Chauvet Tiger DMX 60 Návod k obsluze Strana 96

Komentáře k této Příručce